WDC WD60EZAZ-00SF3B0 HDD Repair Case Studies:
We repaired WD Desktop 6TB SMR Hard Disk This WD 6TB 3.5-inch SMR HDD Stopped Working.
Then User Sends us this HDD we find HDD has multiple Problems like Bad Sectors, Smart Status BAD, and Firmware also damage.
Our Expert find a Solution for this SMR HDD and Finally our Data Recovery And HDD Repair Expert Abdur Rahim Sopon fixed this HDD.
WDC WD60EZAZ-00SF3B0
FW 0073004R
Head 6
3 Plater
PCB :2060-810011-001
family: VeniceR
CONFIGURATION GENERAL INFORMATION:
**************************************
Device type………………………………………………… : Fixed device and/or controller
Device interface……………………………………………. : SATA (SATA Rev 2.6)
SATA Gen1 Signaling Speed (1.5Gb/s)…………………………… : [YES]
SATA Gen2 Signaling Speed (3.0Gb/s)…………………………… : [YES]
Rotation Rate………………………………………………. : 5400
Main data
*****************************
Model……………………………………………………… : WDC WD60EZAZ-00SF3B0
Serial number………………………………………………. : WD-XXXXXXXXXXXXX
Firmware…………………………………………………… : 80.00A80
WWN……………………………………………………….. : 50014EE2BF307A78
Current Logical Parameters
*******************************
Cylinders………………………………………………….. : 16 383 16 383
Heads……………………………………………………… : 16 16
Sectors……………………………………………………. : 63 63
Capacity…………………………………………………… : 16 514 064 sect. 7.87 GB
Capacity available in LBA Mode……………………………….. : 268 435 455 sect. 128 GB
Capacity available in LBA 48 Mode…………………………….. : 11 721 045 168 sect. 5.458 TB
Security system
****************************
password set……………………………………………….. : [NO]
HDD Locked…………………………………………………. : [NO]
HDD Frozen…………………………………………………. : [NO]
wrong password count exceeded………………………………… : [NO]
security erase support………………………………………. : [YES]
security level……………………………………………… : High
Capabilities
******************************
Standby timer values supported……………………………….. : [YES]
IORDY supported…………………………………………….. : [YES]
IORDY disabled……………………………………………… : [YES]
LBA supported………………………………………………. : [YES]
DMA supported………………………………………………. : [YES]
PIO MODE
***************************
PIO MODE 3 Support………………………………………….. : [YES]
PIO MODE 4 Support………………………………………….. : [YES]
Available DMA Mode
**************************
Multiword DMA Mode 0………………………………………… : [YES] Selected
Multiword DMA Mode 1………………………………………… : [YES]
Multiword DMA Mode 2………………………………………… : [YES]
Active UDMA/33 modes
***************************
Ultra DMA/33 Mode 0…………………………………………. : [YES]
Ultra DMA/33 Mode 1…………………………………………. : [YES]
Ultra DMA/33 Mode 2…………………………………………. : [YES]
Ultra DMA/33 Mode 3…………………………………………. : [YES]
Ultra DMA/33 Mode 4…………………………………………. : [YES]
Ultra DMA/33 Mode 5…………………………………………. : [YES]
Ultra DMA/33 Mode 6…………………………………………. : [YES]
Timing
*******************************
Minimal multiword DMA cycle time……………………………… : 120 ns
Recommended multiword DMA cycle time………………………….. : 120 ns
Minimal multiword PIO cycle time w/o stream control…………….. : 120 ns
Minimal multiword PIO cycle time with IORDY……………………. : 120 ns
Supported standards
*******************************
ATA – 3……………………………………………………. : [YES]
ATA/ATAPI – 4………………………………………………. : [YES]
ATA/ATAPI – 5………………………………………………. : [YES]
ATA/ATAPI – 6………………………………………………. : [YES]
ATA/ATAPI – 7………………………………………………. : [YES]
ATA8-ACS…………………………………………………… : [YES]
POWER MANAGEMENT
****************************
Mandatory power manement…………………………………….. : [YES] Enabled
Power up standby……………………………………………. : [NO]
Advanced power manement……………………………………… : [NO]
Advanced power manement value………………………………… : 0
AUTOMATIC Acoustic Management
********************************
Feature set………………………………………………… : Not supported
Current value………………………………………………. : 0
Vendor recomended value……………………………………… : 0
Supported Command Sets
*****************************
NOP……………………………………………………….. : Supported Enabled
READ BUFFER………………………………………………… : Supported Enabled
WRITE BUFFER……………………………………………….. : Supported Enabled
Host Protected Area feature set………………………………. : Not supported
DEVICE RESET command………………………………………… : Not supported
SERVICE interrupt…………………………………………… : Not supported
Release interrupt…………………………………………… : Not supported
Look-ahead…………………………………………………. : Supported Enabled
Write cache………………………………………………… : Supported Enabled
PACKET Command feature set…………………………………… : Not supported
Power Management feature set…………………………………. : Supported Enabled
Removable Media feature set………………………………….. : Not supported
Security Mode feature set……………………………………. : Supported
SMART feature set…………………………………………… : Supported
FLUSH CACHE command…………………………………………. : Supported Enabled
Device Configuration Overlay feature set………………………. : Not supported
SET MAX security extension…………………………………… : Not supported
SET FEATURES subcommand required to spinup after power-up……….. : [NO]
Power-Up In Standby feature set………………………………. : Not supported
Removable Media Status Notification feature set………………… : Not supported
DOWNLOAD MICROCODE………………………………………….. : Supported Enabled
Trusted Computing feature set………………………………… : Not supported
Device Sector Info
*****************************
Multiple logical sectors per physical sector…………………… : [YES]
Logical Sector Longer than 256 Words………………………….. : [NO]
Logical sectors per physical sector…………………………… : 8
Alignment of logical blocks within a larger physical block………. : 0
Words per Logical Sector…………………………………….. : 256 512 b
